- Store
- >
- TOOLS FOR MACHINISTS
- >
- Arbor Press Magnetic Pin Press 3/8" Chuck Tool
Arbor Press Magnetic Pin Press 3/8" Chuck Tool
Mathews Engineering
Arbor Press Magnetic Pin Press Chuck Tool
Instructions: Wear safety glasses when using this tool!
Use this 3/8" key-less chuck to hold press out pins for your arbor press. The pin chuck assures that your press pin is held perpendicular to the pressing force. The back of the chuck has a powerful neodymium magnet that holds the pin chuck to the underside of your 1" square arbor. (The chuck will also work on larger arbors.) The chuck is designed to hold drill rod press tools up to 3/8" and has an internal back stop that transfers the pressing force to the press out pin. When loading the press out pin, insert it all the way into the chuck and tighten the chuck. This is a very useful shop tool for pressing out bearings, roll pins, hinge pins, dowel pins, etc. Also useful for holding round items on any magnetic surface or vertically on a surface plate.
The chuck with the magnetic back plate is 2.5" high. The distance from the back plate to the top of the internal backing pin is 1.735". So, if you use a 2" press out pin overall tool length will be (1.735" + 2.0") = 3.735"
INCLUDED:
Key-less 3/8 inch chuck with internal back stop
Magnetic adapter base with protective rubber boot
Dowel drill rod starter assortment:
1/16" x 1.5"
3/32" x 2"
1/8" x 2"
1/4" x 2"
3/8" x 2"
A larger 1/2" chuck version of this product is also available (part number ARPT0.5)
Made in the USA
instsheet0.375web.pdf | |
File Size: | 991 kb |
File Type: |